Mr-Glass Construction in Sunnyvale, CA

Mr-Glass Construction in Sunnyvale, CA | Spruce Contractors

We provide independent Mr-Glass service across Sunnyvale, handling shower enclosures, custom glass, and hardware repairs for homes from the 94085 corridor to the Cupertino edge and the 94087 Eichler tracts. The thing that makes our work different here is that we already know how Sunnyvale’s post-and-beam framing, radiant slabs, and all-electric permit sequencing throw wrenches into a standard glass install. We’re not authorized by Mr-Glass, but we work on their systems every week because so many Sunnyvale bathrooms were built around them. Call (877) 265-5771 for a free estimate.

Call (877) 265-5771

Why Sunnyvale Residents Choose Us for Mr-Glass Service

Mr-Glass enclosures are common in Sunnyvale because they fit the clean, minimal look that pairs well with mid-century ranch and Eichler-influenced homes. We’re familiar with their sliding barn-door systems, pivot enclosures, and custom tempered panels. Nate Calloway, our owner, grew up in Hillsborough and spent years on job sites across San Mateo County before running projects in Sunnyvale. That background matters when a 1962 ranch in 94086 has a hinge plate pulling loose from old framing. We source OEM Mr-Glass rollers, hinges, sweeps, and seals where the series is still supported, and match to quality aftermarket hardware when it’s not. We measure actual glass thickness and hole patterns rather than assuming. See our broader Mr-Glass sales & service page for the full scope.

Common Mr-Glass Construction Problems We Solve in Sunnyvale

• Roller and track wear on sliding shower doors. Sunnyvale’s long dry summers put fine dust in the air, and combined with hard-water film, that dust accelerates roller binding. Doors start to jump, hang, or grind. We replace worn rollers and re-align tracks before the glass itself starts chipping.
• Bottom sweep and seal failure causing water tracking. In older 94086 and 94087 baths, the shower pan was often never re-sloped, so a degraded sweep sends water onto the tile and into the subfloor. We replace the sweep and check the pan slope at the same time.
• Hinge and pivot loosening on frameless enclosures. These 1950s-60s ranch homes settle, and post-and-beam walls flex. A pivot point that was tight at install gets loose over years of seismic movement. We re-secure blocking behind the wall and replace worn hardware.
• Glass-edge chipping and hardware corrosion. Many original Mr-Glass installs in Sunnyvale lacked proper clear-coat or gasket protection. Small interior baths with moisture cycling make it worse. We assess whether the panel can be saved or needs replacement.
• Out-of-square openings on rebuild projects. Tear-downs and ADU additions in 94085 and 94089 often have framing that isn’t perfectly plumb. We template Mr-Glass panels to the actual opening, not the blueprint, so the glass fits the wall that exists.

Mr-Glass Service in Sunnyvale: What Local Conditions Mean for Your Equipment

Sunnyvale’s all-electric reach code is the factor that catches most homeowners off guard. A bathroom remodel that swaps a gas water heater or adds a heat-pump unit now triggers permit-level electrification review at the One-Stop Permit Center. That changes how we sequence a Mr-Glass shower install. The enclosure has to be templated after final plumbing and electrical rough-in are settled, not before. On a 1962 ranch in the 94087 Eichler-influenced tract near Mr-Glass in Santa Clara territory, our crew pulled a failing Mr-Glass semi-frameless pivot enclosure where the hinge plate had loosened against the post-and-beam wall framing and the glass was tracking water onto the tile curb. We re-secured the blocking, replaced the worn pivot hardware and sweep, and re-templated a frameless panel to the corrected opening. The homeowner was also replacing a gas fixture, so we coordinated the template date around the electrification permit. The glass wasn’t cut to a wall that would move again. Good work doesn’t need a lot of explaining – you can see it.

Mr-Glass Models & Products We Service in Sunnyvale

We work on Mr-Glass frameless sliding shower door systems, including barn-door and single-pivot styles. We also service semi-frameless pivot and neo-angle enclosures, custom-cut tempered glass panels, mirror and wall-glass programs, and sliding closet and bypass door hardware. Parts come from two paths: OEM Mr-Glass rollers, hinges, sweeps, and seals when the series is still supported, and quality aftermarket matches when OEM is discontinued. If the glass is sound and only hardware failed, we repair. If panels are chipped, mis-drilled, or the enclosure is out of square with a failing pan, we recommend replacement and walk through the tradeoffs honestly. We stock common roller sets and sweeps locally so a Sunnyvale service call doesn’t mean waiting a week for parts.

Mr-Glass Service Pricing in Sunnyvale

FAQs – Mr-Glass Construction in Sunnyvale

Service Areas Near Sunnyvale

We serve Sunnyvale and the surrounding communities. Our crews regularly work in Santa Cruz, Twin Lakes, Pasatiempo, Live Oak, Soquel, and Capitola. If you’re in Mr-Glass service in Mountain View or Mr-Glass service in Los Altos Hills, we cover those areas too. Full coverage details are on our Sunnyvale service area page.

Book Your Mr-Glass Service in Sunnyvale Today

Call (877) 265-5771 to schedule a free Mr-Glass estimate in Sunnyvale. We’ll measure your existing glass, check the wall framing and pan slope, and give you a written line-item quote before any work starts. Estimates are free.

Written by Nate Calloway, Owner at Spruce Contractors, serving Sunnyvale and the surrounding Bay Area.